HMISIMATIC HMI KTPVerified · sol.ls-electric.com
SIMATIC HMI KTP 320000 — Touch out of calib
Warning — monitor· AUTO-RESET
CAUSE
Why does it occur?
Touch coordinates are off — panel aging or noise
REMEDY · Step by step
How to fix it?
Re-run the touch calibration from the Control Panel
Do not reset repeatedly before identifying the cause. Repeated resets while ignoring a trip/alarm can cause secondary damage (IGBT failure, motor winding damage, etc.).
SOURCE
Related manual page
Summary based on the official Siemens AG manual. For accurate and complete information, always consult the official manual.
Open official manual ↗CALLBACK
Request an expert callback
A 12-year automation/SI engineer responds directly. Reply within 1–3 business days.