ServoMR-J4Verification pending — cross-check with the official manual
MR-J4 AL.37 — Parameter error
Trip — immediate stop
CAUSE
Why does it occur?
- - Parameter setting is incorrect. - Point table setting is incorrect. Detail No. Detail name Cause Check method Check result Action Target 37.1 Parameter setting range error (
- A parameter was set out of setting range. Check the parameter error No. and setting value. It is out of setting range. Set it within the range. [A] [B] [WB] [RJ010] [GF] It is within the setting range. Check (2). (
- A par
REMEDY · Step by step
How to fix it?
Verify and reset the parameters
Do not reset repeatedly before identifying the cause. Repeated resets while ignoring a trip/alarm can cause secondary damage (IGBT failure, motor winding damage, etc.).
SOURCE
Related manual page
Summary based on the official Mitsubishi Electric manual. For accurate and complete information, always consult the official manual.
Open official manual ↗