ServoiX7NHVerified · sol.ls-electric.com
iX7NH AL-34 — AL-34 Encoder Z Phase Open
Trip — immediate stop
CAUSE
Why does it occur?
Encoder Z-phase disconnection. (For motors without a Z phase, e.g. step motors, mask AL-34 via bit 14 of warning mask [0x2014].)
REMEDY · Step by step
How to fix it?
- Check the encoder cable for disconnection and replace if needed
- If it recurs after power cycling, replace the motor/drive
Do not reset repeatedly before identifying the cause. Repeated resets while ignoring a trip/alarm can cause secondary damage (IGBT failure, motor winding damage, etc.).
SOURCE
Related manual page
Verified · sol.ls-electric.com
Open PDF ↗iX7NH Series AC Servo Drive User Manual V1.7 (EN)
p.397