InverterFR-F800Verification pending — cross-check with the official manual
FR-F800 E.CTE — Circuit fault
Trip — immediate stop
CAUSE
Why does it occur?
- When the power supply for the operation panel (PU connector) is shorted, the power output is shutoff and the inverter trips
- The use of the operation panel (parameter unit) and the RS- 485 communication via the PU connector are disabled
- To reset, enter the RES signal from the terminal, reset via communication through the RS-485 terminals, or switch power OFF then ON again. When the power supp
REMEDY · Step by step
How to fix it?
Check PU and cable. Check the connection of the RS-485 terminals.
Do not reset repeatedly before identifying the cause. Repeated resets while ignoring a trip/alarm can cause secondary damage (IGBT failure, motor winding damage, etc.).
SOURCE
Related manual page
Summary based on the official Mitsubishi Electric manual. For accurate and complete information, always consult the official manual.
Open official manual ↗