ServoPEGAVerified · sol.ls-electric.com
PEGA AL-70 — AL-70 Factory Setting
Critical — power cycle required
CAUSE
Why does it occur?
Factory setting error / drive fault.
REMEDY · Step by step
How to fix it?
- Contact the service center
- If it persists after phase-current offset tuning, replace the drive
Do not reset repeatedly before identifying the cause. Repeated resets while ignoring a trip/alarm can cause secondary damage (IGBT failure, motor winding damage, etc.).
SOURCE
Related manual page
Verified · sol.ls-electric.com
Open PDF ↗PEGA Integrated Servo System Manual V1.4 (202006 EN)
p.212