ServoMR-JEVerification pending — cross-check with the official manual
MR-JE AL.E6 — Servo forced stop warning
Warning — monitor
CAUSE
Why does it occur?
- The forced stop (EM
- signal turned off, causing servo forced stop. Operation is still possible after reset.
REMEDY · Step by step
How to fix it?
- Check the EM2 signal wiring and the source of the forced stop command
- Reset the warning to resume
Do not reset repeatedly before identifying the cause. Repeated resets while ignoring a trip/alarm can cause secondary damage (IGBT failure, motor winding damage, etc.).
SOURCE
Related manual page
Summary based on the official Mitsubishi Electric manual. For accurate and complete information, always consult the official manual.
Open official manual ↗CALLBACK